Hioki IM3536 - Hardware to the Instrument Appx

Appx.12
Attaching Rack-mounting Hardware to the Instrument
Appx. 9 Attaching Rack-mounting Hardware to the
Instrument
WARNING
Observe the following precautions regarding the mounting screws to
avoid instrument damage and electric shock accidents.
• When installing the Rack Mounting Plate, the screws must not intrude more
than 6 mm into either side of the instrument.
• When removing the Rack Mounting Plate to return the instrument to stand-
alone use, replace the same screws that were installed originally. (Feet: M3 × 6
mm, Sides: M4 × 6 mm)
Parts removed from this instrument should be stored in a safe place to enable future reuse.
See "Installation instructions" (p. 12) also.
Rack mounting brackets can be attached to the instrument.
Spacer (Two Required) Unit: mm
Rack Mounting Plate (JIS)
Unit: mm
Unit: mm
Rack Mounting Plate (EIA)