Hioki IM3536 - 2 Measurement Preparations

25
Screen Layout and Operation
Setting detailed settings such as measurement conditions (SET screen)
This screen is for conguring the measurement conditions you want to change and other advanced
settings.
Select the measurement mode (p. 24) before conguring the advanced settings.
(Example screen: LCR mode)
For more information about the continuous measurement (CONTINUOUS) mode screen, see “4 Using
Continuous Measurement Mode” (p. 93)
1
Touch the SET key.
2
Touch a tab.
BASIC Basic setting
Rdc DC resistance measurement
setting (shown during LCR
mode operation only)
ADVANCED Application settings
3
Touch the key for the parameter you
wish to set.
The settings screen for the parameter will
be displayed.
4
Congure settings for LCR mode and
continuous measurement mode.
See “3 Performing Measurements in
LCR Mode” (p. 39), and “4 Using Con-
tinuous Measurement Mode” (p. 93).
1
Overview