Hioki IM3536 - (Saving Measurement Results)

86
Setting Application Settings
Memory function (saving measurement results)
You can save the measurement results inside the instrument (Up to 32,000 items).This function al-
lows you to save previously saved measurement results to the USB ash drive and to acquire them
from a computer using the
:MEMory?
communications command.
When using communications commands, the information saved to memory reects the
:MEASure:VALid
.
For more information about acquiring measurement results stored in memory and how to congure
the
:MEASure:VALid
setting, see the LCR application disc (communications commands).
IMPORTANT
Changing the memory function setting will cause data stored in the instrument’s memory to be
deleted.
Screen display method (For more information, see p. 24):
(Measurement screen) SET key>(SET screen) ADVANCED tab>MEMORY key
1
After touching the OFF key to disable the
memory function, use the  keys to
set the number of measurement results.
1
2
Settable range: 1 to 32000
The number of measurement results can
only be set when the memory function is
set to OFF.
2
Touch the IN key or ON key.
Measured values in the
instrument’s memory are
deleted once they have
been saved to the USB
ash drive. The measure-
ment values are saved
to the MEMORY folder in
the USB ash drive. The
le name is automatically
assigned from the date
and time (p. 143).
Clears all of the
saved measure-
ment values
from the instru-
ment memory.
IN Measured values are stored in memo-
ry only when all parameters judged by
the comparator and BIN measurement
yield a pass result. (If even one HI or
LO comparator result is received or if
the BIN result is OUT OF BINS, the
value will not be saved.)
ON Saves all measurement values to
memory.
If the comparator and BIN functions have not
been congured, the IN and ON keys result
in the same operation.
3
Touch the EXIT key twice.
Displays the measurement screen.