Hioki IM3536 - Page 259

Appx.17
Initial Settings Table
Setting Items Default setting
Initialized initiated on
instrument
Initialization
initiated with
command
Reverts to default value
at power-on
Panel save/ Load
File save/ Load
*
RST
:PRESet
Application
settings
Conductivity/
dielectric
constant
Capacitance Cs ← ← ← No Yes Yes
Sample length 20.00000 mm ← ← ← No Yes Yes
Sample
cross-sectional
area
12.00000 mm
2
← ← ← No Yes Yes
Judgment
result
Delay between
judgment results and
EOM
―――
0.0000 s ← ← ← No No Yes
Reset ON ← ← ← No No Yes
IO trigger
ENABLE ON ← ← ← No No Yes
Edge DOWN ← ← ← No No Yes
IO EOM
Mode HOLD ← ← ← No No Yes
EOM
―――
output time 0.0050 s ← ← ← No No Yes
IO BCD
ON/OFF OFF ← ← ← No No Yes
Position of the
decimal point
9.99999G/
9.99999G
← ← ← No No Yes
High-Z reject
ON/OFF OFF ← ← ← No Yes Yes
Judgment reference
value
1000% ← ← ← No Yes Yes
Contact check
Timing OFF ← ← ← No Yes Yes
Threshold 4 ← ← ← No Yes Yes
Delay time 0.0000 ← ← ← No Yes Yes
Display digits 6/6/6/6 ← ← ← No Yes Yes
LCD Display ON/OFF ON ← ← ← No No Yes
Beep sound
Judgment result NG ← ← ← No Yes Yes
Key ON ← ← ← No No Yes
Beep tone A ← ← ← No No Yes
Key-lock
ON/OFF OFF ← ← ← No No Yes
Passcode 3536 ← ← ← No No Yes
Comparator
(LCR mode)
Mode ABS/ABS ← ← ← No Yes Yes
Absolute
value mode
Upper limit value OFF/OFF ← ← ← No Yes Yes
Lower limit value OFF/OFF ← ← ← No Yes Yes
Percent
mode
Deviation
percentage
mode
Reference value
1.0000 k
/10.0000
← ← ← No Yes Yes
Upper limit value OFF/OFF ← ← ← No Yes Yes
Lower limit value OFF/OFF ← ← ← No Yes Yes
10
9
8
7
6
5
4
3
2
1
Appx.
索引