Hioki IM3536 - Page 263

Appx.21
Initial Settings Table
Setting Items Default setting
Initialized initiated on
instrument
Initialization
initiated with
command
Reverts to default value
at power-on
Panel save/ Load
File save/ Load
*
RST
:PRESet
Interface
Response data to measured value
acquisition query
*3
(
:MEASure:VALid
)
10 ← ← ← No No Yes
Measured value automatic output
*3
(
:MEASure:OUTPut:AUTO
)
OFF ← ← ← No No Yes
Transfer format
*3
(
:FORMat:DATA
)
ASCII ← ← ← No No Yes
Long format
*3
(
:FORMat:LONG
)
OFF ← ← ← No No Yes
File
Save Format OFF ← ← ← No No Yes
Save folder AUTO ← ← ← No No Yes
Header
Date and time ON ← ← ← No No Yes
Measurement
conditions
ON ← ← ← No No Yes
Measurement
parameters
ON ← ← ← No No Yes
Delimiter ,(Comma) ← ← ← No No Yes
Quote "(Double quote) ← ← ← No No Yes
Touch panel calibration No calibration
No
Change
*5
No
Change
No
Change
No No No
Clock No setting
No
Change
*4
No
Change
No
Change
No No No
*1: All 10 ranges will be initialized as described.
*2: The panel’s save type (SAVE TYPE) is not saved in HARD mode.
*3: Setting can only be changed using commands.
*4: Setting will not change, even during a full reset.
*5: Setting reverts to its factory default during a full reset.
10
9
8
7
6
5
4
3
2
1
Appx.
索引