Hiwin D1-N Series User Manual

D1-N Series Servo Drive User Manual Servo Drive Configuration
HIWIN MIKROSYSTEM Corp. 5-71
MD17UE01-1906
5.9.4 Stand-alone mode
In stand-alone mode, the servo drive will drive the motor by using internal path planning. For more
information, please refer to section 3.1.4. The setting of stand-alone mode should include mode selection.
(1) Mode selection
For mode selection, please refer to below.
Table 5.9.4.1
Step Figure Description
1
After Lightening is opened, click on
the icon of Configuration center on
the toolbar. Or click on Conf./Tune
on the menu bar and select
Configuration center.
2
In Configuration center, click on
Mode tab.
3
In the setting page of Mode, select
Stand-alone mode.
After setting, go to the setting page of Drive to set the input power of the servo drive, please refer to
section 5.2.5. Click on OK button to save the setting to the servo drive RAM. After setting all the
parameters, save the settings to Flash by referring to section 5.8.1.

Hiwin D1-N Series Specifications

General

Brand	Hiwin
Model	D1-N Series
Category	Amplifier
Language	English