Honeywell DR4500A - 5. Operation

115
Release K DR4500A Classic Series Circular Chart Recorder With or Without Control Product Manual 115
May 2013
5. Operation
5.1 Overview
Introduction
This section gives you all the information necessary to monitor and operate your recorder and for
performing routine maintenance tasks. In this section assume that the recorder has been properly installed
and configured, and that the inputs are properly calibrated.
Some of the procedures in this section are required only initially, and some are required only randomly, as
conditions dictate. Once the recorder is up and running, required operation actions are infrequent and
straightforward.
Review the Operator Interface, Display and Keypad descriptions shown in Section 1 Overview.
What’s in this section?
This section contains the following topics:
Topic
See Page
0H5.1 1HOverview
2H115
3H5.2 4HPreparation
5H116
6H5.3 7HStart-up
8H118
9H5.4 10HMonitoring Your Recorder
11H121
12H5.5 13HOperator Functions
14H128
15H5.6 Operating Modes
17H129
18H5.7 19HSetpoints
20H131
21H5.8 22HSingle Setpoint Ramp
23H133
24H5.9 25HUsing Two Sets of Tuning Constants (PID Values)
26H136
27H5.10 28HUsing Accutune II
29H139
30H5.11 31HAlarm Setpoints
32H142
33H5.12 34HDigital Input Option (Remote Switching)
35H143
36H5.13 37HResetting and Displaying Totalizer Value
38H144
39H5.14 40HMonitoring the External Event Operation
41H146
42H5.15 43H Maximizing Pen Life
44H146
45H5.16 46HRoutine Maintenance
47H147