Release M DR4500A Classic Series Circular Chart Recorder With or Without Control Product Manual 247
April 2017
Index
0
0-10 Volt dc inputs, 37
0–10 Volt inputs, 189
4
4-20 mA auxiliary output wiring, 52
4-20 mA control output wiring, 39
4-20 mA input wiring, 35
4–20 mA inputs, 190
A
AC line power, 30
Accutune II, 139
Alarm hysteresis, 73, 108
Alarm messages, 127
Alarm outputs, 45
Alarm setpoints, 142
Alarms group definitions, 107
Atmospheric pressure compensation, 76, 112
Automatic calibration mode, 198
Automatic local mode, 129
Automatic mode
Return to, 130, 160
Selecting, 129
Automatic remote mode, 129
Automatic switchover, 91
Automatic switchover value, 67, 92
Auxiliary Output, 73, 74
B
Basic recorder components without options, 226
Battery test failure, 210
Baud rate, 75
Bias, 93
Bias for remote setpoint, 67
Burnout, 63
Burnout protection, 85
C
Calibration procedure, 191
Calibration set up, 183
0-10 Volt inputs, 189
4-20 mA inputs, 190
Millivolts and Volts inputs (except 0-10 Volts), 188
RTD inputs, 187
Thermocouple inputs using a compensated calibrator
method, 185
Thermocouple inputs using an ice bath, 184
Thermocouple inputs using the ambient temperature
method, 186
CE Conformity (Europe), 1
CE Conformity special conditions, 7
CE conformity special conditions (Europe), 27
Chart high range value, 86
Chart lamp, 147
Replacing, 147
Chart low range value, 86
Chart plate assembly parts, 224
Chart speed selection, 65
Chart time line, 118
CHN indicator, 128
Circuit-breaker, 30
Communications station address, 75, 111
Condensed specifications, 8
Configuration procedure, 60
Configuration prompts, 56
Configuration tips, 59
Control algorithm, 68, 96
Control output direction, 67, 94
Controller dropoff value, 67, 94
Current proportional output calibration, 195, 200
Current simplex, 98
Current/relay duplex, 98
Current/time duplex range, 68
Customer support, 204
Cycle time (heat), 102
Cycle time 2 (cool), 102
To Next Page
Loading...
Need help?
General
