Honeywell DR4500A - Page 174

Setpoint Ramp/Soak Programming and Operation - Entering the Setpoint Program Data
160 DR4500A Classic Series Circular Chart Recorder With or Without Control Product Manual Release M
April 2017
Step
Operation
Press
Action/Result
5
Change the value or
selection of a function
prompt
▲ or ▼
This changes the value or selection in the upper
display. If the display blinks, you are trying to select an
unacceptable value.
6
Enter value or selection
into memory
FUNC
This enters the value or selection and goes to another
prompt.
 Repeat steps 4 and 5 for each function you want to
change.
7
Exit configuration
LOWR
DISP
This exits from the configuration mode.