Honeywell DR4500A - Page 176

Setpoint Ramp/Soak Programming and Operation - SP RAMP1 and SP RAMP2 Set Up Group
162 DR4500A Classic Series Circular Chart Recorder With or Without Control Product Manual Release M
April 2017
SP RAMP1 and SP RAMP2 worksheet
Use this worksheet to make a record of your SP RAMP1 and SP RAMP2 settings.
Prompt
Description
Range
Your selection
SP RAMP1
Accesses prompts for Control Loop 1’s
profile
N/A
N/A
SP PROG
Enables SP Program prompts.
ENABLE
DISABLE
ENABLE
RECYCLES
Number of Recycles
0-99
SOAK DEV
Deviation Value
0.0-99
PROFILE
Number of profile to run
1-6
STATE
Program State at end
DISABL
HOLD
RECOVERY
Program resumes after power
interruption
ENABLE
DISABLE
PROG END
SP value after last segment
LASTSP
FSAFE
SP RAMP2
Accesses prompts for Control Loop 2’s
profile
N/A
N/A
SP PROG
Enables SP Program prompts.
ENABLE
DISABLE
ENABLE
RECYCLES
Number of Recycles
0-99
SOAK DEV
Deviation Value
0.0-99
PROFILE
Number of profile to run
1-6
STATE
Program State at end
DISABL
HOLD
RECOVERY
Program resumes after power
interruption
ENABLE
DISABLE
PROG END
SP value after last segment
LASTSP
FSAFE