. . . . .
LOGGING ON AND GETTING STARTED
Setting Preferences
MAXPRO NVR 5.0 Installation and Configuration Guide 103
Configuring the Diagnostic Settings
1. Click the Preferences option in the User menu, . The Preferences dialog box
(Figure 5-20) appears.
2. Click the Diagnostic Settings tab.
Figure 5-20 Diagnostic Settings tab
3. Under Change log level settings, select the check boxes corresponding to logs as
applicable.
4. Click Apply.
5. Click OK to close the Preferences dialog box.
Configuring the Advanced Settings
Encryption secures the communication between server and client. You can encrypt the data
between client to server using encryption feature. MAXPRO NVR supports three types of
encryption modes to communicate with NVR box through client. Each encryption has specific
pre-requisites. The following are the pre-requisites for each encryption mode.
• Default Encryption : None
• Windows Authentication Encryption:
• System clock time should be synced between client and server machine. It also
recommended to use the time sync utility to sync the time between client and
server.
• Workgroup: If the machines are in workgroup then the password used by a
client to log on as a windows user should be the same as Server PC.
• Domain User: All valid domain users are allowed to log on.
• Certificate Based Encryption:
• System clock time should be synced between client and server machine. It is
also recommended to use the time sync utility to sync the time between client
and server.
• Certificate needs to be installed in all Client and Server PCs. A client without a
certificate is not allowed to log on.
• Internet connection is required to Install the certificate.
• Certificate Based Encryption works across workgroup and domain.
To Next Page
Loading...
Need help?
General