MAXPRO NVR 5.0 Installation and Configuration Guide 45
2
COMMISSIONING MAXPRO NVR
Overview of Commissioning Procedure
Commissioning is the process of setting up the MAXPRO NVR system hardware, installing the
software and configuring the NVR system. At the end of the commissioning process, the
MAXPRO NVR system is equipped for use by operators to perform video surveillance
operations.
Steps in the Commissioning Procedure
The process of commissioning involves the following phases.
• Setting up the MAXPRO NVR system
• Installing the Software in the Server and Client Computers
• Configuring the MAXPRO NVR
• Verifying the Configuration
Setting up the MAXPRO NVR
Setting up the MAXPRO NVR involves:
• Determining the number of MAXPRO
NVR server and client computers at the location.
• Choosing the desired MAXPRO NVR system architecture.
• Connecting the monitors to the MAXPRO NVR. After connecting the monitors, configure
the monitor display properties.
• Connecting the keyboards (for example, Ultrakey) to the MAXPRO NVR unit.
See the Setting up the MAXPRO NVR Turnkey Box Solutions section on page 47 for
information on how to setup the MAXPRO NVR XE/SE/PE or MAXPRO NVR Hybrid XE/SE/PE
system.
See the Setting up the MAXPRO NVR Software-Only Solution section on page 52 for
information on how to setup the MAXPRO NVR Software installed on a 3rd party Server.
Installing the Software in the Server and Client
Computers
Note: Full/Fresh installation is NOT required on Honeywell’s boxed solutions: MAXPRO
NVR XE, SE, PE and MAXPRO NVR Hybrid XE, SE, PE. Fresh client installation is
only required on client computers.
To Next Page
Loading...
Need help?
General