CONFIGURING MAXPRO NVR
Configuring the Cameras
142 MAXPRO NVR 5.0 Installation and Configuration Guide
6
The encoder is discovered as a single device in the Cameras Discovered pane, and “n”
number of cameras (where n is the number of channels supported by the encoder) are added
under Camera as shown in the following figure.
Note:
• For AXIS encoders, n+1 streams are typically added (might vary by models)
with 1 additional stream providing the matrix view of all cameras. This matrix
view added can be deleted if it is not required by the user.
To discover and configure the AXIS Camera/Encoders as an ONVIF device in
MAXPRO NVRs, see Appendix B
MAXPRO®NVRs - AXIS Camera/Encoders
Discovery and Configuration (using ONVIF)
section on page 343.
• For multi-channel encoders and multi-imager 180/360 cameras with single IP,
only one channel license is consumed. Maximum System limit is 64 cameras
including, the cameras connected through encoders and the
cameras/streams connected from the multi-imager is 180/360 cameras.
Multistream or Dual stream is not supported for encorders.
Figure 6-18 Adding the Encoder
Note: The Video Channel Number field can be modified, but it is recommended that
you do not change the information in this field.
To Next Page
Loading...
