CONFIGURING MAXPRO NVR
Configuring the Honeywell cameras with MAXPRO NVR Wizard
114 MAXPRO NVR 5.0 Installation and Configuration Guide
6
•Click BACK to return to the CONFIGURATION page or click DONE when the
number of cameras discovered equals the number of connected cameras.
Caution: Only Honeywell IP cameras and HVE encoders (except Honeywell
Performance Series and New equIP® Series IP cameras) are discovered
and added in the MAXPRO NVR Wizard. To discover and add other third
party PSIA/ONVIF compliant cameras, see the Discovering and Adding
Third Party ONVIF and AXIS Cameras section on page 139. For adding
and configuring third party RTSP cameras, the RTSP settings must be
specified, see Adding RTSP Cameras/Encoders section on page 144.
Note: MAXPRO NVR Wizard discovers only 1 channel for multi-channel Encoders and
allows you to add only 1 channel from the wizard that is first channel. You can
add the additional channels from the Camera tab.
3. Step 3 - The INSTALLATION page (Figure 6-4) appears.
Figure 6-4 INSTALLATION page
To Next Page
Loading...
Need help?
General