MAXPRO NVR 5.0 Installation and Configuration Guide 349
C
Appendix C
Patches Released on Top of NVR 4.0
This chapter lists the various patches that are released on top of MAXPRO NVR 4.0. It also
explains the enhancements that you can experience after installing the specific patch.
In this chapter...
AXIS Patch
Patch Version: (Build 87H_T2 patch)
Installation: To be installed on top of MAXPRO NVR 4.0
ISSUES FIXED
The following are the issues fixed in this patch:
• AXIS camera stops responding after upgrading the firmware version to 6.30.1. This
issues is fixed by providing AXIS new Firmware support 6.XXXX.
• Fixed the SMART VMD Issue: Recording is not in progress for the cameras which are
configured only for motion based recording. However, motion based alarms are
generated.
Skylake Patch
Patch Version: (NVR 4.0 SP1 Build 97)
Installation: To be installed on top of MAXPRO NVR 4.0
RELEASE HIGHLIGHTS:
This Patch includes the following enhancements:
1. Supports Sky-Lake Processor
2. For Archival under Delete Archived Recordings After > Continuous recording drop-
down, new deletion schedules are implemented such as 2,3,4 and 5 years as highlighted
below.
Section See page...
AXIS Patch 331
Skylake Patch 331
To Next Page
Loading...
