CONFIGURING MAXPRO NVR
Configuring the System Settings
120 MAXPRO NVR 5.0 Installation and Configuration Guide
6
Note: The default Archival Schedule configured and recommended is Every Day at
12:00 AM. This is recommended versus the Auto [24/7] option for optimal
performance and load on NVR.
The default Archival Schedule configured and recommended is Every Day at 12:00 AM. This is
recommended versus the Auto [24/7] option for optimal performance and load on NVR.
Edge Sync Settings
Edge Sync settings enables you to set the schedule for synchronizing the recordings from the
camera SD card. This feature is supported for Profile-G compliant cameras where the
recordings are stored at the camera level.
Under Edge Sync Recording at:
•Click Every option and then select the time in minutes or hours to synchronize the
recordings.
Or
Click Every Day at option to set the specific time in hours during which the
synchronizing should trigger.
• Limit Past Sync: This option allows you to set number of days passed for which you
want system to sync the recordings from camera. For example - if you set 10 days,
then system will sync the recording within last 10 days from camera.
Manual Archival
Manual archive can be performed in Search tab. You need to search and then archive the
required recording. Before performing the manual archive ensure that you configure the drive
in Disk tab and select the Drive Purpose as Archival. See Configuring the Disk Management
Settings section on page 122.
To perform manual archive:
1. Navigate to Search tab and search the required Recording. Refer MAXPRO NVR
Operator’s Guide, How to search for recorder video and events section for more
information. The recorded video is searched based on the search conditions. The search
results are listed in the Results window.
2. In the Results pane, select the required recording from the list of recording. Press Ctrl to
select multiple recordings.
To Next Page
Loading...
