SECURING MAXPRO NVR
Changing the default Windows Password for Windows Logon user on MAXPRO NVR
268 MAXPRO NVR 5.0 Installation and Configuration Guide
11
Changing the default Windows Password
for Windows Logon user on MAXPRO NVR
Note: For Honeywell turnkey box solutions (XE, SE, PE) with v4.0 or later shipped from
factory, the default Windows user name is NVR-Admin and Windows password is
Password$123.
You can customize and change the default password.
To change the default password
1. Change the Windows password. Perform the steps as explained in the Step1: Changing
the Windows password section on page 269.
2. After changing the Windows password you should update the user credentials of Task
Schedules with the new username/password created. See Step 9: Update the user
credentials of Task Schedules with new user account (For EX: NVRTestUser) section on
page 262.
Changing the Windows Password for
NVRServiceUser on MAXPRO NVR
Note: For Honeywell turnkey box solutions (XE, SE, PE) with v4.0 or later shipped from
factory, the default service user name is NVRServiceUser and Windows
password is tZN"&4x!sF.
You can customize and change the default password.
To change the default password
1. Change the Windows password. See the Step1: Changing the Windows password
section on page 269.
After changing the Windows password, perform the following:
2. Change the password for the following MAXPRO NVR Services. See the Step 2: Changing
the NEOStorageServer, NEOStorageServer2, Trinity Smart VMD Service, TrinityServer,
TrinityController passwords, and TrinityArchival. section on page 269.
• NEOStorageServer
• NEOStorageServer2
• TrinityServer
• TrinityController
• Trinity Smart VMD Service
•TrinityArchival
To Next Page
Loading...
Need help?
General