. . . . .
CONFIGURING MAXPRO NVR
Configuring the Cameras
MAXPRO NVR 5.0 Installation and Configuration Guide 151
Adding Axis 360/180 Camera
To add Axis 360/180 camera
Note: v3.1 SP1 or later supports discovering and adding Axis 360/180 models. Earlier
these were supported through RTSP only in v3.1 or lower versions.
1. In MAXPRO NVR, click the Configurator tab. The System page displays by default.
2. Click the Camera tab to open the Camera page.
3. Click Auto Discovery button. The Auto Discovery screen is displayed and the discovery
starts by default.
• If discovery is stopped then click Start Discovery to discover the cameras in the
network. The cameras are added based on the IP range and Video Format settings.
See the Configuring the Auto Discovery Settings section on page 135 for more
information. Only device integrations with auto discovery support are discovered
automatically in the NVR. All other devices need to be added manually. For Axis
M3007-PV and M3027-PVE model cameras, ONVIF should be enabled on the
camera prior to discovery. see Appendix B, MAXPRO®NVRs - AXIS
Camera/Encoders Discovery and Configuration (using ONVIF) section on page 343.
4. After the discovery, to add the Axis 360/180 camera models, select the check boxes of
Axis 360/180 camera model as shown in Figure 6-25. Axis 360/180 cameras are listed in
the discovery pane with their model numbers for example Axis M3007 and so on.
Figure 6-25 Discovering AXIS 360 Camera
To Next Page
Loading...
Need help?
General