SETTING UP THE MAXPRO NVR
Setting up the MAXPRO NVR Software-Only Solution
52 MAXPRO NVR 5.0 Installation and Configuration Guide
3
Setting up the MAXPRO NVR Software-Only
Solution
Setting up the MAXPRO NVR server and client computers is the first phase in the
commissioning process.
Before you Begin
Determine the following at the location.
• Number of server and client computers required.
• Hardware configuration of the computers.
• Number of peripheral devices such as joystick controllers (Ultrakey keyboard), and
other devices that are needed.
Hardware Specifications
The MAXPRO NVR server and client computers must meet the minimum hardware
specifications, refer to the MAXPRO NVR Software Data Sheet for more information.
MAXPRO NVR Software System Architecture
MAXPRO NVR software solution can be set up in the following two ways:
• Standalone System
• Distributed System
Corresponding system architectures are displayed below
MAXPRO NVR Software Solution Standalone System
The following figure illustrates the MAXPRO NVR Standalone system.
Figure 3-5 MAXPRO NVR Software Solution Standalone System
To Next Page
Loading...
Need help?
General