. . . . .
CONFIGURING MAXPRO NVR
Configuring the Disk Management Settings
MAXPRO NVR 5.0 Installation and Configuration Guide 125
You can also view a graphical illustration of the drive statistics with legends for each of the
above fields see Figure 6-9.
Figure 6-9 Graphical Illustration
•In the Recording recycle at box, type a value. The Recording recycle refers to a
state when the oldest video recordings are automatically deleted, if there is no disk
space on the drives for new video recordings.
•In the Low disk alarm at box, type a value. The Low disk alarm refers to a state when
the space on the drives for video storage is nearing the maximum size of the drives.
Caution: The Low disk alarm at value must be always greater than the Recording
recycle at value.
Tip: Click Refresh to refresh the information under Disk Space at any point in time.
5. Click Add Drive to add a fixed drive or a network drive.
• The fixed drive that you are adding must be available on the MAXPRO NVR system,
else an “Invalid Drive” text displays in the Total Space (GB) column.
• Add Network Drive using map drive as \\Drivename\Folder.
• Add a network drive path in the following format: \\<IP address >\<folder name>
for example, \\192.168.1.12\Recorded Clips.
Note: The Network drive added must be valid with proper folder permissions set for the
installed default user, else an Invalid Drive text displays in the Total Space (GB)
column.
To Next Page
Loading...
Need help?
General