Honeywell MAXPRO NVR Series - Figure 6-50 Privacy Protection Settings; Figure 6-51 Anonymization Camera Level

CONFIGURING MAXPRO NVR
Privacy Protection Settings (GDPR Favored)
190 MAXPRO NVR 5.0 Installation and Configuration Guide
6
Figure 6-50 Privacy protection Settings
At Camera Level
At camera level user can enable or disable the Anonymization based on the requirement.
1. In Configurator > Camera tab, navigate to the camera properties for the specific
camera.
2. Under Primary Stream > Preference tab, select the Anonymization Enabled check box
as shown below. By default it is not selected.
Figure 6-51 Anonymization Camera Level
At User level
An Administrator can enable Anonymization for a specific user in Users tab. The
corresponding user will be able to view only anonymized video.
1. Navigate to Configurator > User tab.
2. For the required User, select the Anonymization check box as shown below. By default it
is Enabled for all the operators.