CONFIGURING MAXPRO NVR
Configuring the Cameras
166 MAXPRO NVR 5.0 Installation and Configuration Guide
6
mapped to their respective input and output ports. The first input/output port is mapped to the
first camera, similarly the second camera is mapped to the second input/output port of the box
and so on. The input output combinations cannot be mapped to any other analog or IP
camera other than the default configuration.
The below figures depicts the typical input and output ports (Highlighted in Red) and RS-485
connectors for MAXPRO NVR Hybrid XE, SE and PE Box. The SENSOR is the input port and
CONTROL is the output port for both Hybrid XE Figure 6-39 and SE Box Figure 6-40. The
detailed input and output ports for NVR Hybrid PE box is shown in Figure 6-42.
To Next Page
Loading...
