Honeywell MAXPRO NVR Series - Upgrade to MAXPRO NVR 4.7 Build 188; To upgrade to MAXPRO NVR 4.7 Service Pack

. . . . .
UPGRADE MAXPRO NVR SOFTWARE
Overview
MAXPRO NVR 5.0 Installation and Configuration Guide 207
Upgrade to MAXPRO NVR 4.7 Build 188
Direct Upgrade to 4.7 is supported as explained below:
• From NVR 4.0 87 Rev H to NVR 4.7 Build 188
• From NVR 4.0 97 Rev B to NVR 4.7 Build 188
• From NVR 4.1 Build 123 Rev B to NVR 4.7 Build 188
• From NVR 4.5 Build 162 Rev B to NVR 4.7 Build 188
To upgrade to MAXPRO NVR 4.7 Service Pack
1. Double click MAXPRO NVR 4.7 Setup.exe. The WinRAR self extracts the files and
displays the Windows update message.
2. Click Yes to proceed, the installation wizard starts and the Welcome page appears.
Figure 8-8 Welcome Wizard
3. Click Continue to start the installation. The installation process continues and once the
installation is complete the completion page is displayed as shown below.
Note: If Korean language is not installed in your previous build (such as NVR 4.5 Build
162) then a confirmation message to support Korean Language is displayed.
Click Yes if required.