MAXPRO NVR WEB CLIENT
220 MAXPRO NVR 5.0 Installation and Configuration Guide
9
3. Under Stream Quality Configuration:
• Select the required Frames Per Second options as applicable and then click Save.
The available options are:
• As Per Frame: Select this option to view the video as per the camera stream
settings. If the camera supports 30 frames per second to stream the video then
you can view 30 frames per second and accordingly your bandwidth is
consumed. By default As Per Frame option is selected and it is recommended
not to change this option, because this provides you with the best quality video.
• Only IFrame: select this option if your bandwidth is low and if you want to view
only one IFrame per second.
Note MAXPRO NVR Web Client supports streaming quality resolution up to
1080p. Cameras configured above 1080p resolution are not supported. If
you drag and drop a camera configured with megapixel resolutions
(above 1080p) then a message appears and video is not displayed as
shown below.
4. Under Protocol Configuration:
• Click the appropriate Protocol options for secure communication. The available
options are HTTP, HTTPS, HTTPS (Only Video). By default HTTP and HTTPS
protocol is selected.
Note
• Video to the Web Client is always transmitted over HTTP. Non-video data is
transmitted over HTTPS/HTTP based on the protocol configuration settings.
• Please ensure ports required for both video and non-video data are
considered in any port forwarding settings required.
To Next Page
Loading...
