4-74
Diagnostic Tests and Utilities
HP Designjet 4000/4020 Printer Series Service Manual
10. Media standby behavior
The purpose of this Service Utility is to set the way the printer holds the
media in standby mode.
Perform the utility as follows:
1 In the Service Utilities submenu, scroll to "Media standby behavior” and
press Enter.
2 There are three different standby behaviors to choose from:
Remain at standby
This is the default behavior
Unload
If the media has been at the standby position for more than 260 hours, the
printer will unload the following types of media:
– Coated
– Heavy weight Coated
– Super Heavyweight Coated
– Any Gloss
Trim after resume
If the media has been at the standby position for more than 260 hours, the
first 20cm will be trimmed before printing on the following types of media:
– Coated
– Heavy weight Coated
– Super Heavyweight Coated
– Any Gloss
Use the Up and Down keys to select the Media Standby Behavior and
press the Enter key.
P
HO
N
E
S
UP
PO
R
T
To Next Page
Loading...