5-3
Service Calibrations
HP Designjet 4000/4020 Printer Series Service Manual
Entering the Service Calibrations Menu
1 Once the message "Ready" is displayed on the front-panel, scroll to the
"Printer Setup Options" icon and press the Enter key.
2 Once inside the "Printer Setup Menus" menu, press the UP or Down arrow
key and the Cancel key together. You are now in the Service Tools Menu.
3 Use the Arrow keys to scroll to the "Service Calibrations" menu and press
the Enter key.
4 Use the Arrow keys to scroll through the "Service Calibrations" selections
and press the Enter key to begin a specific operation when the required
Service Calibration is highlighted.
If the printer is not used for 135 seconds, the printer exits out
of the Service Calibrations Menu and you must repeat the
above steps to enter Service Calibrations again.
Press UP
Press Cancel
OR
DOWN
To Next Page
Loading...
Need help?
General