4-48
Diagnostic Tests and Utilities
HP Designjet 4000/4020 Printer Series Service Manual
12. Set Unit Configuration
The purpose of this test is to automatically configure the Printer either as
Standard or Productivity.
Set the Unit Configuration as follows:
1 In the Diagnostics Tests submenu, scroll to "12. Set Unit Configuration" and
press Enter.
2 The Printer will start the configuration process and the Front Panel will
display the following messages:
îš„ Starting Nvm.
îš„ Getting Part Number: (will show either Q1273A/Q1274A /Q1271A/
Q1272A/CM765A/CM766A).
If there is a failure at this point, the Front Panel will display System Error
Code 79:03. For more information on troubleshooting this error code, refer
to Page 2-21.
3 The following message will be displayed on the Front Panel. Press any key to
finish the configuration.
If there is a failure at this point, the Front Panel will display System Error
Code 79:03. For more information on troubleshooting this error code, refer
to Page 2-21.
4 Once the process is completed, OK will be displayed on the Front Panel.
To Next Page
Loading...
Need help?
General