4-4
Diagnostic Tests and Utilities
HP Designjet 4000/4020 Printer Series Service Manual
10 Others ⇒ Page 4-37
This option allows you to:
Recover the Printer from a Bag Broken error ⇒ Page 4-37.
View the information relating to the IO ⇒ Page 4-40.
View the Firmware Version, Part Number, Serial Number and PS Unit
Configuration ⇒ Page 4-41.
Verify which Ink Cartridges are valid for the purge process and what is
their current available ink level ⇒ Page 4-43.
Enable or disable the printer’s connectivity, dependnig on the customer’s
security requirments. ⇒ Page 4-45
11 EEROM Reset ⇒ Page 4-46
The purpose of this test is to reset the EEROM values.
12 Set Unit Configuration ⇒ Page 4-48
The purpose of this test is to automatically configure the Printer either as
Standard or Productivity.
13 Error 71:19 Recovery ⇒ Page 4-49
The purpose of this utility is to set the Serial Number and Part Number in
case both the Hard Disk Drive and the Ink Supply Tubes are replaced at the
same time.
14 I/O Tests ⇒ Page 4-51
The purpose of this test is to check the installed and active I/O Interfaces.
To Next Page
