General System Configuration
Enabling System Logging
To display logging messages stored in access point memory, use the show
event-log command, as shown in the following example.
HP420#show event-log
Mar 29 15:13:45 Notice: 802.11g:SSID 1 ::Station Authenticated: 00-09-5b-a3-c6-98
Mar 29 15:13:21 Information: 802.11g:SSID 8 ::Interface Enabled
Mar 29 15:13:21 Information: 802.11g:SSID 7 ::Interface Enabled
Mar 29 15:13:21 Information: 802.11g:SSID 6 ::Interface Enabled
Mar 29 15:13:21 Information: 802.11g:SSID 5 ::Interface Enabled
Mar 29 15:13:21 Information: 802.11g:SSID 4 ::Interface Enabled
Mar 29 15:13:21 Notice: Auto Channel Scan selected 2412 MHz, channel 1
Mar 29 15:13:12 Information: 802.11g:SSID 1 ::Interface Enabled
Mar 29 15:13:12 Information: 802.11g:Radio has been started
Mar 29 15:09:04 Information: 802.11g:SSID 1 :: Open System updated to 1
Mar 29 15:09:04 Information: 802.11g:SSID 1 ::Description updated to Guest Access
Mar 29 15:09:04 Information: 802.11g: SSID 1 :: VlanId set to 2
Mar 29 15:07:24 Information: 802.11g:Transmit Power set to 20 percent
Mar 29 15:07:24 Information: 802.11g:SSID 8 ::Interface Enabled
Mar 29 15:07:24 Information: 802.11g:SSID 7 ::Interface Enabled
Mar 29 15:07:24 Information: 802.11g:SSID 6 ::Interface Enabled
Mar 29 15:07:24 Information: 802.11g:SSID 5 ::Interface Enabled
Mar 29 15:07:24 Information: 802.11g:SSID 4 ::Interface Enabled
Mar 29 15:07:24 Notice: Auto Channel Scan selected 2412 MHz, channel 1
Mar 29 15:07:14 Information: 802.11g:SSID 1 ::Interface Enabled
Press <n> next. <p> previous. <a> abort. <y> continue to end :
5-44
To Next Page
Loading...
