General System Configuration
Configuring RADIUS Accounting
To display the current RADIUS server settings from the Exec level, use the
show radius command, as shown in the following example.
HP420#show radius
11g Radius Authentication Server Information
============================================================================
ssid IP Port Retransmit Timeout Mac-format Vlan-format
============================================================================
1 (P)0.0.0.0 1812 3 5 NO_DELIMITER HEX
1 (S)0.0.0.0 1812 3 5 NO_DELIMITER HEX
2 (P)0.0.0.0 1812 3 5 NO_DELIMITER HEX
2 (S)0.0.0.0 1812 3 5 NO_DELIMITER HEX
3 (P)0.0.0.0 1812 3 5 NO_DELIMITER HEX
3 (S)0.0.0.0 1812 3 5 NO_DELIMITER HEX
4 (P)0.0.0.0 1812 3 5 NO_DELIMITER HEX
4 (S)0.0.0.0 1812 3 5 NO_DELIMITER HEX
5 (P)0.0.0.0 1812 3 5 NO_DELIMITER HEX
5 (S)0.0.0.0 1812 3 5 NO_DELIMITER HEX
6 (P)0.0.0.0 1812 3 5 NO_DELIMITER HEX
6 (S)0.0.0.0 1812 3 5 NO_DELIMITER HEX
7 (P)0.0.0.0 1812 3 5 NO_DELIMITER HEX
7 (S)0.0.0.0 1812 3 5 NO_DELIMITER HEX
8 (P)0.0.0.0 1812 3 5 NO_DELIMITER HEX
8 (S)0.0.0.0 1812 3 5 NO_DELIMITER HEX
============================================================================
11g Radius Accounting Server Information
============================================================================
index IP AcctPort Retransmit Timeout InterimUpdate
============================================================================
1 (P) 192.168.1.25 1813 5 10 7200
2 (S) 192.168.1.13 1813 3 5 3600
============================================================================
HP420#
5-57
To Next Page
Loading...
