HP 420 - Page 55

Using the HP Web Browser Interface
Tasks for Your First HP Web Browser Interface Session
To change the default community names for SNMP v1 or v2c management
access, follow these steps:
1. Select the Configuration tab.
2. Click the [
SNMP] button.
3. For SNMP State, select Enable to enable SNMP management.
4. For SNMPv3 Only, select Disable to enable access from SNMP v1 and v2c
clients.
5. Type text strings to replace the default community names for read-only
and read/write access.
6. Click the
[Apply Changes] button.
Figure 4-5. Setting SNMP Community Names
4-11