Using the HP Web Browser Interface
Tasks for Your First HP Web Browser Interface Session
3. If you select to use a static IP address, you must manually enter the IP
address and subnet mask.
4. If a management station exists on another network segment, enter the IP
address of a gateway that can route traffic between these segments.
5. Enter the IP address for the primary and secondary DNS servers to be
used for host-name to IP address resolution.
6. Click the
[Apply Changes] button.
No t e If you change the IP address using the web interface, you must log in again
using the new address.
Figure 4-9. IP Configuration
4-15
To Next Page
Loading...
