FusionModule2000 Smart Modular Data Center
Installation Guide
11 Installing Cable Troughs and Cable Trays
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
By default, clamp the clasps into the two holes in the middle. In actual conditions, you can select holes
as required.
Figure 11-7 Installing a partition plate
Step 6 Install adjacent cable troughs in the same way.
Step 7 Rotate the interconnecting lever and clamp it into the clasps until the lever is horizontal. This
operation interconnects the cable troughs.
Figure 11-8 Installing an interconnecting lever
(1) Interconnecting lever
Step 8 Install the cable trough above the rear door in a similar way.
----End
To Next Page
Loading...
