System Setup Screen 109
User Guide v 2.3 — September 2015 System Setup Screen
Table 10-1 System Setup Screen Item Descriptions
Item Description
Serial Number The Serial Number is for informational purposes only. It is a
number assigned to the system when it is manufactured. Husky
support may ask for this number when troubleshooting or
upgrading Altanium.
Model Controller model name.
Software Version The Current Software Version is for informational purposes only.
Husky support may ask for this number when troubleshooting or
upgrading Altanium.
Company Name Company name displayed on the status bar.
Manual Standby Duration
Timer
Zone temperature decreases for a given time duration or until a
set standby temperature is achieved.
Manual Boost Duration Timer Zones temperature increases for a given time duration or until a
set boost temperature is achieved.
Remote Standby Duration
Timer
Once an external signal has activated the remote standby mode,
the system cools down to the remote standby setpoint for the
duration of the timer setting.
Remote Standby Delay Timer Once an external signal has activated the remote standby mode,
the system waits for a set period of time (delay period) until
cooling down to the remote standby setpoint.
Remote Standby Input Mode The standby setting is enabled based on one of three settings:
trigger, on/off, or direct.
Trigger: Includes a delay timer and duration timer. If the D/I signal
is lost, Standby or Boost mode continues until the duration timer
elapses.
On/Off: Includes a delay timer. If the D/I signal is lost, the controller
returns to the running state.
Direct: System enters Standby until the input signal is not active. If
the input signal is active when the system is started it will
immediately go into standby mode. Includes a delay timer.
Remote Boost Duration Timer Once an external signal has activated the remote boost mode, the
system heats up to the remote boost setpoint for the duration of
the timer setting.
Remote Boost Delay timer The system will initiate the remote boost mode after a set period
of time.
Remote Boost Input Mode The boost setting is enabled based on one of three settings: a
trigger, an on/off setting, or a direct signal.
Language Language displayed on the user interface.
Force Temperature Units To Forces the temperature units to specified settings.
Units Units of measure (SI or Imperial) displayed on the user interface.
To Next Page
Loading...
