Graphical View Screen Overview 61
User Guide v 2.3 — September 2015 Making Adjustments
Item Description
Temperature Bars Each individual bar on the screen represents a single zone of temperature
control. Each bar is labeled above with the zone number. The text shown
at the base of each bar is the actual temperature for that zone.
The different colors in each bar have a different meaning.
• The green area represents the molding window.
• The white hairline represents the setpoint.
• An arrow represents the actual temperature.
• If the arrow is yellow, the temperature is not within the graph
range.
• If the arrow is black and splits the line, the temperature is at the
setpoint.
• The yellow area in the zone bar represents the alarm window
• The red and blue areas in the zone bar represents the abort window.
• A blank gray bar indicates that the zone is turned off.
Amperage Bars The amperage bars, directly below the zone bars, are light blue. These
show the amperage being drawn by each heater. The text shown at the
base of each bar is the actual current reading for that zone.
Power Bars The power bars are located directly below the amperage bars. These
show the percentage of power being applied to the heater. The text at
the base of each bar is the actual power output percentage being
delivered to that zone.
• If a zone is in Auto (closed loop) regulation, the bar will fill with
orange depending on the percentage of power output.
• If a zone is in Manual (open loop) regulation, the bar will fill with
green depending on the percentage of power output.
• If a zone is set to Monitor mode, the bar will remain grey (there is no
power output for zones set to Monitor mode).
To Next Page
Loading...
