Intel® Server System S7000FC4UR TPS System Chassis and Sub-Assemblies
Revision 1.0
77
9. System Chassis and Sub-Assemblies
This section describes the system chassis and its sub-assemblies.
9.1 Base Chassis and Top Covers
9.1.1 Base Chassis
The system fits into a standard 19-inch EIA rack and is 4U high x 28-inches deep. The 4U
height is defined by standard EIA rack units where 1U = 1.75-inches. The depth, as measured
from the front mounting flange to the back of the PCI slots, does not include cables or a bezel.
The chassis is modular for ease of serviceability and manufacturability. All major modules in the
chassis are easily accessible. Hot-swap component replacement capability is provided for:
System fans
Hard drives
Memory riser boards
PCI slots
Power supplies
All system FRUs can be replaced without any loose hardware.
9.1.2 Top Cover
The top cover is a single-piece design. It attaches to the chassis with a series of slot features in
the sides of the chassis that mate with features in the top cover.
9.1.3 Slide Rails
The server chassis accommodates slide rails for mounting the chassis into standard 19-inch
racks. The keyhole features on the slide rails attach to studs on the sides of the chassis. No
tools or screws are needed.
To Next Page
Loading...
Need help?
General
