190 JVL Industri Elektronik A/S - User Manual - Integrated Stepper Motors MIS23x, 34x, 43x
9.3 Programming menu
The menu found at the top of the main window gives access to the following options:
TT2173GB
Described elsewhere in this chapter
Upload the program from the module to MacTalk
Program + Source
Program + Source - REM
Program only
Shows the memory usage if the program
(compiled)+source program and remarks
is downloaded into the module.
Same as above but without remarks.
Same as above but without source
program and remarks.
Checksum
Lines
Mode
Shows the checksum of the complete
program downloaded into the module.
The checksum is unique and can be used
o verify whether the program in the
module matches the original program or
not.
The number of program lines used in the
source program (MacTalk)
Specify the program type actually used.
Skip initialization (advanced)
Bypasses internal initialization routines after powerup.
(Only for very special use).
Program + Source + Remarks
Default. Choosing this will transfer everything down into the
module memory. This can be an advantage if remarks
and source program must be uploaded to MacTalk later.
Program + Source
Program only
Same as above but without remarks.
Onl
the com
iled
ro
ram is transfered.
To Next Page
Loading...
Need help?
General
