Krone Big Pack 890 XC - Page 479

Terminal – machine functions [Medium Plus/Comfort Plus Electronics] 8
Displays on the working screen 8.3
Supplement to Operating Instructions 150000773_00_en
BiG Pack 1270, BiG Pack 1270 XC, BiG Pack 1290, BiG Pack 1290 HDP, BiG Pack 1290 HDP XC, BiG Pack
1290 XC, BiG Pack 890, BiG Pack 890 XC
35
Icon Designation Explanation
94 / 240 cm
Bale length display • The black value and the bar indicate
the current bale length.
• The blue value and the red mark
indicate the set target bale length.
• The blue value is touch-sensitive.
Icon Designation Explanation
Bale channel flap pressure
in bar or PSI (depending on
selected system of units)
In manual mode
• The black value under the bar display
and the bar indicate the current bale
channel flap pressure.
• The blue value under the bar display
and the red mark indicate the set target
bale channel flap pressure.
• The blue value is touch-sensitive.
Force of pressure as % In automatic mode
• Display for the baling force on the right
and left in the bale channel.
• The black value under the bar display
and the bar indicate the current baling
force.
• The blue value under the bar display
and the red mark indicate the set target
baling force.
• The display may fluctuate considerably.
The control only functions when the
packer is supplying crops to the piston.
• The bale channel flap pressure is
automatically set by the system based
on the measured plunger force.
• The blue value is touch-sensitive.
Icon Designation Explanation
Flywheel brake applied
Blade cassette not up
Knot run Is displayed briefly after a knot is tied.
When the knotter signal is activated, a horn
sounds for approx. 1s, refer to page53.
Bale ejector active
Self-steering axle locked
Warning beacon switched
on
Warning beacon switched
off