Krone BiG X 770-3 - Unfulfilled Switching-On Conditions and CAN Bus Disturbances

Info centre "EasyTouch"
255
8.6.1 Unfulfilled switching-on conditions and CAN bus disturbances
Depending on the selected diagnostics menu, non-fulfilled switching-on conditions and errors
are displayed in the terminal. There is a difference between:
– non-fulfilled switching-on conditions (yellow)
– CANBUS errors (red)
Overview of non-fulfilled switching-on conditions
Symbol
Description
Symbol
Description
Diesel engine speed is not at 1950
rpm
Lifting unit is too low / is not low
enough
Diesel engine has not been
started
Spout not parked
Diesel engine not off
Spout not up
Idle speed of diesel engine 1100
rpm is not reached
Intake OFF / not OFF
Vehicle speed incorrect
Intake ON / not ON
Switch the “autopilot” release
switch on or off
Cutting drum running / not running
Switch the “intake/header” release
switch on or off
Cutting drum stopped / not
stopped
Switch the “traction drive” release
switch on or off
Pendulum frame is not horizontal
Switch the “road/field” release
switch on or off
Grinding flap closed
Switch the “parking brake” release
switch on or off
Grinding flap open
Seat switch (no one on the driver’s
seat)
Header not folded out
“Quick stop console” switch on or
off
Header not folded in
“Quick stop manual operation”
switch on or off
Header off/not off
Open or close door
Header on/not on
Switch the “maintenance” release
switch on or off
Grass mode is not set
Main coupling on/off
Maize mode is not set
Lifting unit too high/not high
enough
XDisc mode is not set
Table 2