Info centre "EasyTouch"
441
8.19 Cleaning and Maintenance
Danger! - When performing repair, maintenance or cleaning work on the machine , or in
the case of technical intervention, drive elements may start moving.
Effect: Danger to life, injuries or damage to the machine.
• Switch off the engine and remove the ignition key.
• Secure the machine against accidental start-up and against rolling!
• The cutter blades can continue to rotate after the drive has been switched off. Only
approach the machine once the work tools have come to a complete standstill!
• After completing maintenance work reattach all safety devices properly.
• Avoid skin contact with oil and grease.
• Seek medical help immediately should injuries caused by oil escaping under pressure
occur.
Damage to the silage additives unit due to low outdoor temperatures.
If there is any water left in the silage additives unit prior to it being stored for the winter, the unit
is at danger of being damaged by frost.
• Fill the silage additives tank with a biological, non-aggressive frost protection agent prior to
storing it for the winter and allow the silage additives unit to pump in "continuous operation"
mode for 2 minutes with a dosing quantity of 50%.
• After the winter, before the season begins, fill the silage additives tank with clear water and
allow the silage additives unit to pump in "continuous operation" mode for 10 minutes with a
dosing quantity of 75%.
The silage additives unit must be cleaned after each use, see page 637.
Notice
The silage additives residue and the rinsing water must be disposed of properly (see
instructions of the silage additives manufacturer in the separate operating instructions).
If the throughput is weak, the filter insert of the line filter and the nozzle filters must be cleaned,
see page 637.
CAUTION!
Machine damage.
• Never clean the flow sensor with compressed air.
To Next Page
Loading...
