Appendix – CropControl System
63
1.4.6.2 Entering the Weight of the Counterweighing
Notice
While the counterweight for an order is entered, another order may run simultaneously.
Prerequisite:
– The order for which the counterweighing was performed is started or paused, refer to
chapter Operation, “Operating CropControl System with Installed CropControl TC Sync
System via KRONE CCI 200 Operating Terminal”, “Creating CCI 200 Order and Performing
Counterweighing”, “Creating Order”.
CC001005
Fig. 57
• To open the counterweighing list, press
.
CC001006
CC001007
Fig. 58
• Press a counterweighing, for example
and enter a weight
in kg. The counterweighing factor changes and is marked by means of a tick .
Notice
The entered weight is checked for plausibility. If the weight is too big or too small, an error
message is displayed and the weight for the counterweighing is not adopted.
If a value is entered for the last open counterweighing for a paused order, a query will occur
which asks to finish this order.
To Next Page
Loading...
