Krone BiG X 770-3 - Menu 3-10 Calibration of Main Coupling

Info centre "EasyTouch"
298
8.6.10 Menu 3-10 Calibration of main coupling
The main coupling must always be calibrated if
– it does not switch on "smoothly".
– the KMC3 control unit has been replaced.
– parts of the main coupling have been worked on.
– the valve Y12 "Main coupling" or its valve coil have been replaced.
5 6
7 8
B C D BX500657_1
Fig. 228
Prerequisites:
– Quick-stop switch console is switched off.
– Quick-stop switch manual operation is switched off.
– Release switch traction drive is switched off.
– Release road/field is set to field mode.
– Release switch maintenance is switched off.
– The seat switch is actuated (the driver's seat is occupied).
– The door is closed.
Main menu 3 Maintenance is active.
• Using the incremental encoder, choose menu 3-10 "Calibration of main coupling".
• Press the incremental encoder.
The display shows menu level Calibration of main coupling.