Krone BiG X 770-3 - Use

Info centre "EasyTouch"
436
8.17.1 Use
BXSI00002
5 6
7
8
B C D
1
2
3
4
8
9
10
7
6
5
Fig. 337
The flow sensor monitors the flow of silage additives through the silage additives unit. If the flow
sensor is not ready for use, it must be switched off in the settings of the silage additives unit
(input field 9).
Setting the flow sensor status:
Flow sensor is present
Flow sensor is absent
If the flow sensor status is set to absent, a characteristic line of the last characteristic line
recording is used to control the pump.
Notice
If the flow sensor status is set to absent, the silage additives unit cannot determine whether
silage additives are actually being conveyed. In this case it must be ensured that a sufficient
quantity of silage additives is available in order to prevent the pump from running dry (this may
damage the pump).
Setting silage additives unit mode (input field 8):
The following states are possible:
Silage additives unit deactivated
Continuous operation
Automatic mode
Crop flow cleaning headland