Krone BiG X 770-3 - Setting the Discharge Accelerator Rear Wall; Settings on the Installed Grass Channel

Settings
594
19.2.3 Setting the Discharge Accelerator Rear Wall
• Remove the ignition key and secure the forage harvester against accidental start-up and
against rolling away.
• Wait until all units have come to a complete stop
19.2.3.1 Settings on the installed grass channel
Fig. 523
1 Distance between rear wall to the channel support, adjustable via rubber buffer
2 Rubber buffer
3 Moving the rear wall when adjusting the rubber buffers
4 Hinge pin of the rear wall
5 Rear wall pivot on top above the rubber buffer
6 Adjusting setting screw grass channel
7 Movement of the rear wall and grass channel when adjusting the setting screws
8 Raising and lowering of the rear wall when adjusting the setting screws
9 Grass channel hinge pin on the transfer shaft