Operation
557
18.4.4 Manual check of additional axle basic function
The manual check of the additional axle basic function, see chapter 4 "Menu 3-11 "Maintenance
additional axle" (optional)", see page 301.
18.4.5 Function test of additional axle automatic functions
Check automatic function "Lift additional axle":
Switching-on conditions:
– Operating mode = "Maize" (EasyCollect)
– Diesel engine = idling speed.
– Release switch "Road/field" = road mode.
– Release switch "traction drive" = ON
• Manually lower the additional axle all the way.
• Accelerate the machine slowly in the reverse direction. The additional axle must lift fully and
automatically.
• Decelerate the machine to a standstill.
• Switch the release switch "road/field " to field mode.
• Manually lower the additional axle all the way.
• Slowly accelerate the machine in the forward direction. The additional axle must lift fully and
automatically.
Check automatic function "Lower additional axle":
Switching-on conditions:
– Operating mode = "Maize" (EasyCollect)
– Release switch "Road/field" = road mode.
• Read off the value of the parameter 25498 "Lower additional axle speed" on the terminal.
• Manually lift the additional axle all the way.
• On the terminal select menu 4-1-6 "Sensor test additional axle".
• Switch on the release switch "traction drive".
• Accelerate the machine in the forward direction to a speed that is greater than the read
off setting value (parameter 25498).
The additional axle must lower automatically and an error message may not appear in the
terminal.
• Decelerate the machine to a standstill.
If an error occurs during the check, the error message appears in the display with an error code.
For the list of error messages, error descriptions, possible error reasons and error
correction, refer to the appendix – Error messages, see page 761.
To Next Page
Loading...
