Start-up - Maize mode
487
12.5 Further conversion work
Turning the conveyor bars around
Fig. 411
The pre-compression roller (1) features conveyor bars which can be used on alternating sides.
One of the sides of the conveyor bar is smooth, while the other is designed with teeth.
Experience shows that the smooth side works well for use in grass silage while the toothed side
works well with maize.
• Shut down and secure the machine, see page 41.
• Unscrew the fastening screws (3) on the conveyor bar (2).
• Turn the conveyor bar (2) and mount it, tightening torque M8 =17.5 Nm, M10=35 Nm
Note
The conveyor bars must be changed if the wear is so great that the conveyor bars are no
longer higher than the crossbars on the pre-compression and feed roller.
Note
Because of metal detection, only fastening materials made of anti-magnetic steel may be used.
Never punch the screws into the boreholes or use an impact screw driver to tighten them
(magnetisation effect).
To Next Page
Loading...
