Krone BiG X 770-3 - Silage Additive System (External)

Start-up
450
10.2.2 Silage additive system (external)
Abb. 344
There is an option to connect an external silage additive system. The electrical connection (1)
for the silage additive system is located in the cooler compartment to the right beside the
channel support. It is a 3-pin plug bearing the designation XY60.
No fixed location is stipulated for the silage additive system and the injection of silage additives.
If the silage additive system is connected, it is controlled fully automatically via the electronics in
the machine.
The right connector cable (material no.: 303-558-1, length approx. 3 m) is included with the
machine.
Connection assignment of the cables
BX500652
Fig. 345
XY 60 contact 1:
+12 volts switched max. 15 amps through fuse 22-F74
XY60 contact 2:
Ground
XY60 contact 3:
+12 volts continuous voltage, max. 15 amps through fuse 22-F74
For operating and setting the silage additive system (external), see page 432.