Krone BiG X 770-3 - Connecting the Terminal in Case of Self-Propelled Machines

Appendix – CropControl System
4
Pos: 5 /BA/Info-Center/CropControl BiG X 600-1100-1/Hinweis Eichgesetz @ 272\mod_1403170660561_78.docx @ 2048915 @ @ 1
The CropControl system enables a complete yield recording and documentation of the
harvested areas.
Note
The CropControl system does not present a measuring device as defined by law via
measurement and calibration (Eichgesetz).
Pos: 6.1 /BA/Info-Center/CropControl BiG X 600-1100-1Krone CCI 200 Bedieneinheit anschließen @ 354\mod_1438169240886_78.docx @ 2644867 @ 3 @ 1
1.1.1 Connecting the Terminal in case of Self-Propelled Machines
CC000606_1
Fig. 1
For the connection to a self-propelled machine, a special cable set “IN-CAB“ is required. It can
be ordered by stating KRONE number 20 082 207 1.
• Connect interfaces “CAN1-IN” and “CAN1-OUT” on the terminal via “INCAB” cable with
“INCAB” bushing of the machine.
• Mount KRONE CCI 200 control unit or KRONE Delta control unit as described in the
assembly instructions and connect it.
Switch control unit on and off if CropControl is not connected to ISOBUS
• Make sure that the connections on the device are correctly and firmly seated before the
terminal is switched on for the first time.
CC000890
Fig. 2
• To switch the control unit on or off, press key (1) and hold it down for approx. 2 seconds.
Pos: 6.2 /Beipacks/Selbstfahrer/CropControl/Delta Terminal_CAN Widerstand in CAN Einstellungen deaktivieren bei ISOBUS @ 354\mod_1438170896399_78.docx @ 2645031 @ @ 1
In Delta terminal, the CAN resistance must be deactivated before the terminal is used: