Maintenance – supply system
714
24.9 Adjusting the gap between the baling roller and scraper
Prerequisites:
– The feed attachment is removed, see page 657.
– The tension springs (1) on the rear right and left at the intake housing are correctly set, see
page 715.
Preparatory work
• Check the flat roller for wear (leaching). If there is a high level of wear, the function of the
scraper cannot be guaranteed.
• Check the scraper (b) and replace it if the thickness falls below 26 mm.
Fig. 667
Adjusting the gap between the compression roller and scraper
The distance (a) between the compression roller (1) and the scraper (2) must be 6-7 mm.
• Measure the distance (a) between the compression roller (1) and the scraper (2).
If distance (a) is less than 6 mm or greater than 7 mm:
• Loosen the tension springs on the feed attachment, see page 715.
• Insert or remove discs under the bump stop (3) of the feed attachment to set the distance
(a) evenly across the entire width.
• Pretension the tension springs on both sides of the feed attachment, see page 715.
To Next Page
Loading...
