Krone BiG X 770-3 - Settings Information Section; Menu Field Working Width

Info centre "EasyTouch"
176
8.2.4 Settings information section
8.2.4.1 Menu field working width
The settings information section (IV) displays the current working width in the Working width
menu field.
The working width setting is needed to calculate the area.
5 6
7 8
B C D
BX500005_1
IV
Fig. 122
Icon
Designation
Explanation
Grass mode (pick-up)
If grass mode is set, the icon and the set width
(swathed width) in cm or inch are displayed.
Maize mode (EasyCollect)
If maize mode is set, the icon and the set
number of rows with the resulting working width
in cm or inch are displayed.
Direct cutting system (XDisc)
If the direct cutting system is set, the icon and
the set width in cm or inch are displayed.
Temporary change to the working width
If the entire working width of the front attachment is not used, the working width must be
adjusted in the terminal. Only then can the acreage counter correctly calculate the area.
• To reduce the working width, press the
key.
• To increase the working width, press the
key. You can only increase the value up to the
pre-set maximum width.
Alternatively, you can also make the setting with the incremental encoder, see page 163.

NOTE
If you press the key "Raise lifting unit automatically" on the multi-function lever, the pre-set
working width is reset, see page 183.